Hot Shot Replacement Motor For Sabre-Six Electric Livestock Prod

Operation To activate this prod, remove the safety clip from under the button, touch the two brass prongs on the end of the prod to the animal and press the button. A light touch against the animal gives the most effective results. Only apply a shock to the animal as required. Maintaining your HOT-SHOT® Prod It is important to keep you HOT-SHOT® clean and dry for best performance. Follow proper maintenance after each use. 1) Thoroughly CLEAN AND DRY the HOT-SHOT® Livestock Prod after each use: a. Remove shaft from handle and dry connection area of shaft and handle b. Wipe handle with a dry cloth, particularly around the trigger button and end cover areas 2. Inspect shaft tip for damage or excessive wear and replace as necessary 3. Store with shaft separated from unit to allow for complete drying in areas that can't be wiped dry 4. The HOT-SHOT® Prod handle may be stored lying down or hanging from the wrist strap, the shaft may be hung from shaft hang hole in the tip Make sure to dry completely before reassembly. It is also recommended to perform periodic maintenance to your HOT-SHOT® Prod. For more detailed maintenance information visit www.miller-mfg.com Maintaining your HOT-SHOT® Rechargeable Battery Pack (RBP) RBP should be charged for 16 continuous hours before first use. Charge the pack in temperatures between 40-100Ëš F. Charging time may vary depending on ambient temperatures and extent of discharge for both 110 volt charger (R110) and 12 volt charger (R12). HOT-SHOT® charger (R110 and R12) required. Other chargers may damage the pack and will VOID the warranty. Charging times: R12: full charge in 16 hours R110: full charge in 9 hours Periodically run the unit until there is a noticeable drop in output (this exercises the batteries and increases the life of the pack). Break-in your new Rechargeable Battery Pack. It is important to pro