The Floating De-Icer keeps your pond completely ice-free, allowing fresh oxygen to reach your pond for healthy fish! Thermostatic control coupled with thermal feedback protects the unit from overheating. The thermostat is positioned above the heating element for safety in low-water conditions. The float is completely enclosed in a rugged, plastic housing and will not sink over time. Strong stainless steel heating element. Recommended for 100-300 gallons of water. Includes 15-foot cord with anti-rub protector. LOCKNDRY compatible. UL Listed. CSA Listed. 1500 Watts, 120 Volts, 60 Hz. One year warranty.

Keeps pond completely ice free, allowing fresh oxygen to reach the pond to keep fish healthy.
Thermostat positioned above element for safety with over-temperature protection.
Rugged enclosed float will not sink.
15' anti-rub cord.
UL, CSA Listed.

[instruction]INSTALLATION 1. If the unit is to be used in a non-metallic tank or pond, a Model 88R guard must be attached in order to prevent the heating element from coming in contact with the walls of the tank. The 88R guard must be purchased separately. 2. The unit should be placed in a tank or pond with water and then plugged into a Ground Fault Circuit Interrupter. 3. Some animals--particularly horses--may try to remove the 7521 and 7621 de-icers from the tank. To counteract this, you may wish to run the cord through PVC or galvanized tubing extending over the tank. Be sure to allow slack in the cord to compensate for varying water level. 4. The unit is thermostatically controlled so that it will not turn on until the temperature drops to around 40Â°F. If it is removed from the tank, it will turn on and then shuts itself off in about 60 seconds and will then cycle on and off. ATTACHING THE GUARD TO THE DE-ICER Turn the unit upside down and place the guard as shown. Rotate the short spring to thread it onto the guard and the straight section of the heating element. The spring should capture the cross-wire on the guard and be centered around the copper strap as shown. INSTRUCTIONS FOR THE LOCKNDRYÂ® CORDSET (1) Insert the plug into the receptacle just as you would a normal extension cord making sure the plug is fully inserted. (2) Slide the large nut forward to engage the threads on the plug. (3) Rotate the nut to tighten the plug against the receptacle. (4) Slide the second, thinner, red nut forward to engage the threads. (5) Rotate the red nut sn

API Floating Pond De-Icer - 1500 Watt