Motomco Gopher Killer is specifically formulated to kill pocket gophers in outdoor, underground applications around, homes, lawns and farms. Made with Zinc Phosphide, an acute active ingredient that works faster than anticoagulant baits. Labeled for use in plug removal baiting (entrance of tunnels), and main runway baiting. See product label for full instructions.

Specifically formulated for control of pocket gophers.
Approved for manual applications with outdoor, below-ground use.
Includes label instructions for Plug Removal Baiting at entrance to tunnels, or main runway baiting.
Made with Zinc Phosphide, an acute, non-anticoagulant active ingredient.
Zinc Phosphide.

Manufacturers Warnings:

It is a violation of Federal law to use this product in a manner inconsistent with its labeling. READ THIS LABEL: Read this entire label and follow all use directions, use restrictions and use precautions. Harmful if swallowed or inhaled, causes moderate eye irritation, avoid contact with eyes or clothing. Wash thoroughly with soap and water after handling and before eating, drinking, chewing gum, using tobacco, or using the toilet. Wear long sleeved shirt and long pants, shoes plus socks and gloves. Remove and wash contaminated clothing before reuse. Any person who retrieves carcasses or unused bait following application of this product must wear gloves.

Safety Data Sheets:

Click Here to Download Safety Data Sheet

[instruction]APPLICATION DIRECTIONS FOR POCKET GOPHERS: Apply bait to control pocket gophers using one of the two methods outlined below: Plug Removal Baiting: Burrowing pocket gophers (Thomomys spp. and Geomys spp.) throw out low, fan shaped mounds on either side of their underground tunnel. These lateral tunnels coming to the surface are on the flat side of the fan and are plugged with soil. Using a long-handled spoon, carefully remove the plug. Insert one teaspoon of bait as far down as possible. Reclose opening, being careful not to cover bait with soil. Main Runway Baiting: To locate main runways, probe about 6 to 8 inches away from mounds by use of an iron bar, a strong stick, or other suitable implement. Resistance on probe will drop suddenly and probe will fall about two inches when main runway is entered. Carefully enlarge the op