Frame Kit suspends the hutch over the dropping pan so the pan can slide out for easier cleaning. The Frame Kit also conserves space by allowing hutches to be stacked up to four high by bolting frame kits together. Each kit contains four legs, two pan rails, and four sets of bolts, washers, and nuts. Legs are 23.5 inch long by 2.1875 inch wide, made of rust-resistant, heavy-gauge galvanized steel. Straight-blade screwdriver and two 7/16 inch wrenches (not included) required for assembly. Designed to fit the Pet Lodge 24 inch by 24 inch Rabbit Hutch (Item No. AH2424, sold separately).

Suspends the hutch over the dropping pan so the pan can slide out for easier cleaning.
Conserves space by allowing hutches to be stacked.
Includes four legs, two pan rails, and four sets of bolts, washers, and nuts.
Rust-resistant, heavy-gauge galvanized steel.
Designed to fit the Pet Lodge 24 inch by 24 inch Rabbit Hutch (Item No. AH2424, sold separately).

[instruction]Using the ACP2 Wire Clip Pliers: 1. Place ACC1 Wire Cage Clip in the pliers. 2. Position clip next to wires to be fastened. 3. Close the pliers to form clips around wires CAUTION: Avoid pinching skin in pliers. Assembly Instructions: 1. Lay out the hutch panels as shown in Figures 2 - 4. Use the illustration that matches your model hutch. You can put the door on the right or left side of the front of the hutch. 2. Fasten a clip at each. Do not put clips where appears. NOTE: You do not need to be exact in placing the clips. 3. Raise two panels so that they meet at the corner. Fasten clips at each shown in Figure 5. Repeat for the other corners. 4. Attach the door on the inside of the hutch using clips at each shown in Figure 6. 5. Attach the spring and door latch as shown in Figure 6. 6. Slide the vinyl door guards over the edge of the door opening. 7. Place the top panel on top of the side panels. Fasten clips at each shown in Figures 7 - 9. Do not put clips where the appears.[/instruction]

Pet Lodge Rabbit Hutch Frame Kit