This hutch is strong, durable, and rust resistant for indoor or outdoor use. Excellent for rabbits, hamsters, guinea pigs, chinchillas, ferrets, gerbils, and other small animals. Made of chew-proof, easy-to-clean galvanized steel wire mesh. Door is surrounded by protective vinyl guards, with spring-tension door latch. Sides are 2 inch by 1 inch mesh and bottom is 1 inch by 1/2 inch mesh. Hutch measures 24 inch long by 24 inch wide by 16 inch high. Easy assembly required; wire clips are included. Use Pet Lodge Wire Clip Pliers (Item No. ACP2, sold separately). Hutch is stackable up to four high when used with the Pet Lodge Rabbit Hutch Frame Kit (Item No. AHFK24, sold separately). Dropping pan not included.

Chew-proof, rust resistant, easy-to-clean galvanized steel wire hutch for indoor or outdoor use.
Protective vinyl guards around door; spring-tension door latch.

[instruction]Using the ACP2 Wire Clip Pliers: 1. Place ACC1 Wire Cage Clip in the pliers. 2. Position clip next to wires to be fastened. 3. Close the pliers to form clips around wires CAUTION: Avoid pinching skin in pliers. Assembly Instructions: 1. Lay out the hutch panels as shown in Figures 2 - 4. Use the illustration that matches your model hutch. You can put the door on the right or left side of the front of the hutch. 2. Fasten a clip at each. Do not put clips where appears. NOTE: You do not need to be exact in placing the clips. 3. Raise two panels so that they meet at the corner. Fasten clips at each shown in Figure 5. Repeat for the other corners. 4. Attach the door on the inside of the hutch using clips at each shown in Figure 6. 5. Attach the spring and door latch as shown in Figure 6. 6. Slide the vinyl door guards over the edge of the door opening. 7. Place the top panel on top of the side panels. Fasten clips at each shown in Figures 7 - 9. Do not put clips where the appears.[/instruction]