Little Giant Duramate Automatic Waterer

Assembly and Mounting Instructions: Note: The waterer is shipped with the float assembly installed on the right side of the waterer base. The float assembly can be installed on either side of the waterer to best suit your application. Carefully remove the mounting nut and fiber washer from the float assembly and reinstall the float assembly on the left side of the waterer before proceeding if desired. 1. Install the 7/8” plastic plug in the float assembly mounting hole not being used. 2. A 1/2” rubber plug is provided if you wish to add a drain to the waterer base. Drill a 1/2” hole in the flat bottom area of the waterer base and install the plug from underneath (large flange outside the waterer) before proceeding. 3. Wrap the threads of the float assembly with Teflon® thread sealing tape and install the 3/4” hose adapter. 4. Place the hose washer provided into the hose adapter. Push the washer in completely so it sits flat against the shoulder of the hose adapter. 5. Connect the male end of the supply hose provided to the hose adapter. 6. Mount the waterer in one of the following locations: Wall Mounting: a. Position short arm of mounting brackets upward. b. Install mounting brackets under lip of waterer base using bracket mounting holes shown with four (4) 1/4-20 x 1” bolts and 1/4-20 nut provided. c. Select appropriate height and attach mounting brackets to wall (fasteners not provided). d. Attach a 2” x 8” board to the wall b