Little Giant Single Door Live Animal Trap

UNPACKING THE TRAP: 1. Make sure there is no damage from shipping. 2. All parts should move freely. Model LT1 SETTING THE TRAP: 1. Set the trap on a flat surface. 2. Refer to figure 1. 3. Lift long end of the movable Lever to horizontal position. 4. Press the Door Brace fully down against the Door. 5. This step is optional: Rotate the Latch so that it secures the Door Brace against the Door. 6. With Door Brace depressed and Lever in horizontal position, raise the Door up until it touches the ceiling of the cage. Make sure the short end of the Lever is under the Door. 7. VERY IMPORTANT: If Step 5 was done, now rotate Latch to release Door Brace. 8. Place long end of the Lever on inside of Trigger Rod and release the Door slowly. The trap is now set. Note: If the trap is too sensitive, file a flat on both the Lever and the Trigger Rod where they meet. TESTING THE TRAP: 1. Insert a stick or pencil through the trap and press down on the front or rear edge of the Trigger Plate. This will trip the trap causing the Door to spring shut. BAITING THE TRAP: 1. Use the Bait Reference Chart on the back of this instruction sheet to select the proper bait. 2. Carefully place bait centered on the cage floor slightly behind the Trigger Plate. 3. Re-set the trap as instructed. RELEASING THE ANIMAL: 1. Press the Door Brace down against the Door. 2. Rotate the Latch over the top of the Door Brace, securing the Door Brace against the Door. The trap is ready for release of the animal. 3. Turn the cage over on its top. The Door will automatically open, allowing the animal to escape. Models LT2, LT3, LT4 & LT5 SETTING THE TRAP: 1. Set the trap on a flat surface. 2. Refer t